Maintenance — Nose Lift
The nose lift is a TracTive Length Adjustment System (LAS) and provides ??? mm of travel.
| Qty. | Description | Notes | TOOL |
|---|---|---|---|
| 1 | TracTive Hydrauic Pump Assembly | Mounts to the nose floor | n/a |
| 4 | ??? Screws (Stainless Steel) | ??? | |
| 3 | 3AN Male Tee (Stainless Steel) | Mounts to tab on nose subframe | n/a |
| 1 | ??? Screw (Stainless Steel) | See above | ??? |
| 1 | ??? Nyloc (Stainless Steel) | See above | ??? |
| 1 | Left Up Hose | ||
| 1 | Left Down Hose | ||
| ??? |
Hydraulics
Lines
Hi on pump to the top fitting on the damper.
Low on pump to the lower fitting on the damper.
The recommended oil is SAF 5045 EU13 which can only be obtained through TracTive.
CAN Bus
The following is not covered in the documentation.
Nose Up is initiated by a single CAN bus message. The motor runs until it detects a preset current.
Nose Down is initiated by a single CAN bus message and runs for a configured duration. The duration can be set by ???.
The “Slave” CAN bus messages are acknowledgements of the Nose Up and Nose Down commands and are ignored.