Right Side Pod

The lines in right side pod are finished. The approach is the same as the left side pod described here. There’s a lot less going on this side! The lines from top to bottom are:

  • Air Jack (manifold to front jack, -6, aluminum)

  • Heater Supply (engine outlet to heater, -10, aluminum)

  • Heater Return (heater to pump inlet, -10, aluminum)

  • Clutch (master cylinder to throwout bearing, 3/16”, stainless steel)

  • Rear Brakes (residual pressure valve to brakes, 3/16”, stainless steel)

  • Cooling Return (radiator to pump inlet, 1-1/2”, stainless steel)

The air jack line won’t be insulated because it doesn’t carry any heat.

While most of the clamps were 3D-printed, I used NotcHead Line Clamps in several locations. The hard line version requires a solid push on the line which results in a reassuring click.

IMG_0149.jpg
IMG_0151.jpg